Jetstar

Passenger arrested after exiting plane and walking on wing at Melbourne Airport

Share

In a dramatic incident at Melbourne Airport, a passenger was arrested after exiting a Jetstar Airbus A320 plane (reg. VH-FVY) through an emergency exit, walking along the wing, and climbing down a jet engine to the tarmac.

The incident occurred after the flight JQ507 from Sydney had landed and parked. The man, who had displayed erratic behaviour and vaped during the flight, forced open the emergency door, triggering the deployment of an emergency slide. Passengers screamed as he shoved others aside to reach the exit.

Australian Federal Police arrested the man, who was later taken to a hospital for assessment. Charges are expected.

This post was published on 23 August 2024 22:59

André Orban

M. Sc. Engineering

Published by
André Orban

Recent Posts

Romanian airline Dan Air files for insolvency amid €10 million environmental debt

Romanian carrier seeks protection from creditors as total liabilities reach €25.4 million; flight operations face…

23 October 2026

Jetstar bans passenger after he inflates life jacket during safety demonstration

Jetstar and Qantas have banned an Australian social media personality from flying with their airlines…

23 October 2026

Flemish Government suspends new Brussels Airport flight plan over noise concerns

The Flemish Government has invoked a conflict of interest against the proposed changes to flight…

23 October 2026

Brussels Airport to expand border controls as EES delays persist, government registration kiosks remain offline

Brussels Airport will add eight manual border-control positions for arriving passengers by the end of…

23 October 2026

Typhoon Champi forces cancellation of more than 600 flights in Taiwan

Typhoon Champi has disrupted air travel across Taiwan, forcing the cancellation of more than 600…

23 October 2026

Copenhagen Airport faces major security queues after new screening requirements

Copenhagen Airport (CPH) is experiencing major queues at security screening after new requirements introduced by…

23 October 2026